MULTIQUIP MVC88VTH Manuel d'utilisateur télécharger pdf (Page 20)



OPERATION



1. Once the engine has started, move the engine throttle

lever quickly to the run position.

2. With the throttle lever in the run position, the engine

speed should be around 2,300 RPM, therefore

engaging the centrifugal clutch.

3. Firmly gasp the compactor's handle bar with both

hands, the compactor will begin moving forward.

4. Slowly walk behind the compactor and be on the

lookout for any large objects or foreign matter that

might cause damage to the compactor or bodily injury.

5. Compactor traveling speed may drop on soils which

contain clay, however there may be cases where

traveling speed drops because the compaction plate

does not leave the ground surface easily due to the

composition of the soil. To rectify this problem do the

following:

 Check the bottom plate to see if clay or equivalent

material has been lodge in the plate mechanism. If so,

wash with water and remove.

 Remember the compactor does not work as efﬁciently

on clay or soils that have a high moisture content level.

 If the soil has a high moisture level, dry soil to appropriate

moisture content level or carry out compaction twice.



 follow all safety rules referenced

in the safety section of this manual before

operating compactor. Keep work area

clear of debris and other objects that

could cause damage to the compactor or

bodily injury.

NOTICE

 move the throttle lever quickly without

hesitation, because increasing the engine speed slowly

causes the clutch to slip.

NOTICE

stop the engine suddenly while working at

high speeds.





1. Move the throttle lever to the idle position (Figure 20)

and run the engine for three minutes at low speed.

Figure 20. Throttle Lever (Idle)

2. Place the engine ON/OFF switch (Figure 21) in the

"" position.

Figure 21. Engine ON/OFF Switch (OFF Position)

3. Place the fuel shut-off lever (Figure 22) in the "

position.

Figure 22. Fuel Valve Lever (OFF)

4. If applicable place water valve (Figure 18) in the 

position.



1. Move the throttle lever quickly to the  position, and

place the engine ON/OFF switch in the  position.

ENGINE SWITCH

OFF

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 75 76

Commentaires sur ces manuels

Pas de commentaire

MULTIQUIP MVC88VTH Manuel d'utilisateur Page 20

Commentaires sur ces manuels

Produits connexes et manuels pour Moteur MULTIQUIP MVC88VTH