Multiquip CA4HC Manuel d'utilisateur télécharger pdf (Page 17)

CA4HC WALK-BEHIND TROWEL — OPERATION MANUAL — REV. #0 (09/29/06) — PAGE 17

Figure 4. Honda GX120 Engine Controls and Components

INITIAL SERVICING

The engine (Figure 4) must be checked for proper lubrication and

filled with fuel prior to operation. Refer to the manufacturer's engine

manual for instructions & details of operation and servicing. The

engine shown above is a HONDA engine, operation for other

types of engines may vary somewhat.

1. Fuel Filler Cap – Remove this cap to add unleaded

gasoline to the fuel tank. Make sure cap is tightened

securely. DO NOT over fill.

DANGER

CA4HC TROWEL— BASIC ENGINE

2. Throttle Lever – Used to adjust engine RPM speed (lever

advanced forward

SLOW

, lever back toward operator

FAST

3. Engine ON/OFF Switch –

position permits engine

starting,

OFF

position stops engine operation.

4. Recoil Starter (pull rope) – Manual-starting method. Pull

the starter grip until resistance is felt, then pull briskly and

smoothly.

7. Air Cleaner – Prevents dirt and other debris from entering

the fuel system. Remove wing-nut on top of air filter

cannister to gain access to filter element.

Operating the engine without an air

filter, with a damaged air filter, or a

filter in need of replacement will

allow dirt to enter the engine, causing

rapid engine wear.

11. Oil Drain Plug – Remove this plug to remove oil from the

engine's crankcase.

12. Dipstick/Oil Filler Cap – Remove this cap to determine if

the engine oil is low. Add oil through this filler port as

recommended in Table 4.

13. Output Shaft – Drive power is transferred from the engine

output shaft to the gearbox via a V-Belt pulley drive system.

6. Choke Lever – Used in the starting of a cold engine, or in

cold weather conditions. The choke enriches the fuel

mixture.

10. Fuel Tank – Holds unleaded gasoline. For additional

information refer to engine owner's manual.

9. Muffler – Used to reduce noise and emissions.

8. Spark Plug – Provides spark to the ignition system. Set

spark plug gap according to engine manufacturer's

instructions. Clean spark plug once a week.

NOTE

Adding fuel to the tank should be done only

when the engine is stopped and has had an

opportunity to cool down. In the event of a

fuel spill, DO NOT attempt to start the engine

until the fuel residue has been completely

wiped up, and the area surrounding the

engine is dry.

5. Fuel Valve Lever – OPEN to let fuel flow, CLOSE to stop

the flow of fuel.

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 35 36

Commentaires sur ces manuels

Pas de commentaire

Multiquip CA4HC Manuel d'utilisateur Page 17

Commentaires sur ces manuels

Produits connexes et manuels pour Équipement Multiquip CA4HC