MULTIQUIP MQ600TD80 Spécifications télécharger pdf (Page 22)

PAGE 22 —MQ600TD80 TRASH PUMP • OPERATION AND PARTS MANUAL — REV. #11 (10/10/11)

STARTUP

ENGINE OIL

1. Make sure pump/engine is on level ground.

2. Pull the engine oil dipstick from its holder.

3. Verify that oil level (Figure 6) is maintained between

the two notches on the dipstick.

Figure 6. Engine Oil Dipstick

4. If engine oil is low, ﬁll engine crankcase with lubricating

oil through ﬁller hole (Figure 7), but do not overﬁll.

Figure 7. Engine Oil Filler Hole

CAUTION

DO NOT attempt to start the engine unless the pump

has previously been primed with water. Severe damage

to the pump's mechanical seal will occur if pump has not

been primed

5. The oil listed in Table 5 is recommended to ensure

better engine performance. Use class CD or higher

grade motor oil.

FUEL

1. Determine if engine fuel is low by reading fuel indicator

gauge on top fuel cap. Fill with recommended type

diesel fuel. DO NOT ﬁll the tank beyond capacity.

2. Handle fuel in a safety container. If the container does

not have a spout use a funnel.

3. Pay attention to the fuel tank capacity when replenishing

fuel. Refer to the fuel tank capacity listed in Engine

Speciﬁcations Table.

4. Tighten fuel tank cap securely after ﬁlling.

DANGER

NEVER ﬁll the fuel tank while the engine

is running or in the dark. Fuel spillage on

a hot engine can cause a ﬁre or explosion.

If fuel spillage occurs, wipe up the spilled

fuel completely to prevent ﬁre hazards.

DANGER

DO NOT smoke while refueling. Motor

fuels are highly ﬂammable and can be

dangerous if mishandled.

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 75 76

Pas de commentaire

MULTIQUIP MQ600TD80 Spécifications Page 22