MULTIQUIP RX 1510-I Instructions d'exploitation télécharger pdf (Page 64)

RX 1510-C/-I/-CI

– 64 –

NOTE



The addresses at the transmitter and receiver must correspond.Transmitter and

receiver are factory set to address 5.



(only for machines with infrared control)

Setting the transmitter address on the machine controller:

1) Fold the operating panel back.

2) Remove the plug

from the machine controller with a screwdriver

entfernen.

3) Set in the required address by turning the arrow with a screwdriver.

Setting the transmitter address on the infrared control:

Remove the plug „SI“ from the infrared control with a screwdriver entfernen.

• Set the same address as on the machine controller by turning the arrow with

a screwdriver.

Start-up

1 2 ... 59 60 61 62 63 64 65 66 67 68 69 ... 100 101

Pas de commentaire

MULTIQUIP RX 1510-I Instructions d'exploitation Page 64