MULTIQUIP Drums MT-85H Manuel d'utilisateur télécharger pdf (Page 12)

PAGE 12 — MT-85H — PARTS & OPERATION MANUAL — REV. #8 (06/26/01)

MT-85H — OPERATION

This section is intended to assist the operator with the initial

start-up of the MT-85H Tamping Rammer. It extremely important

that this section be read carefully before attempting to operate

the rammer.

DO NOT use your rammer until this section is thoroughly

understood.

CAUTION:CAUTION:

CAUTION:

Failure to understand the operation of the MT-

85H Tamping Rammer could result in severe

damage to the trowel or personal injury.

Rammer Gearbox and Spring Cylinder Oil Bath

This unit uses an oil bath lubrication system. Perform the

following:

1. Check the oil level through the oil level sight glass at the rear

of the tamper foot.

2. If oil is not visible, add 10W-30 motor oil. The bath contains

approximately 1.7 pints (800 cc.)

NOTE

The oil level should be kept at the half

way point of the sight glass.

Engine

Before pouring fuel into the fuel tank (Figure 2) perform the

following:

1. Find a container for the mixing of fuel and gasoline.

2. Use a quality outboard motor oil for 2-cycle engines.

3. Mix gasoline (unleaded) with oil at a 25:1 ratio. Mix well.

4. Be sure to filter the mixed fuel with a strainer at the filler port.

5. If fuel spills on the fuel cap when operating rammer, replace

the rubber leak stopper inside the cap.

Inspection

1. Check all nuts, bolts fasteners for tightness. Retighten as

necessary.

2. Clean any dirt from the recoil starter and foot pedestal. Wipe

the entire unit clean before operating.

3. Replace any missing or damaged Safety Operation decals.

4. Adjust height of handle. Adjust handle by loosening nuts and

moving handle to suit operation. Retighten nuts.

Initial Start-up

When starting the MT-85H Tamping Rammer perform the

following:

1. Open the shut- off valve by moving the strainer lever

downward (Figure 3), then set the engine start/stop switch

(Figure 4) to the "START" position.

Figure 3. Fuel Shut-Off Valve

Figure 4. Engine Start/Stop Switch

Figure 2. Fuel Tank

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 41 42

Commentaires sur ces manuels

Pas de commentaire

MULTIQUIP Drums MT-85H Manuel d'utilisateur Page 12

Commentaires sur ces manuels

Produits connexes et manuels pour Jouets et accessoires MULTIQUIP Drums MT-85H