MULTIQUIP Drums MT-85H Manuel d'utilisateur télécharger pdf (Page 13)

MT-85H — PARTS & OPERATION MANUAL — REV. #8 (06/26/01) — PAGE 13

2. Close the choke lever Figure 3 and move the throttle lever

to the "Full Open" position. Turning the choke lever 90

degrees clockwise closes the choke . In cold weather, start the

unit with choke fully closed. In warm weather or when the

engine is warm, the unit can be started with choke halfway

or completely open.

3. Grip the recoil starter (Figure 6 ) handle and pull it until you

feel a slight resistance. Then pull sharply and quickly. Return

the recoil starter handle to the starter case before releasing.

4. If engine fails to start, move the choke lever (Figure 3) to the

half open position to avoid flooding.

5. Repeat steps 1 thru 4.

6. If the engine does not start after repeated attempts,

check the spark plug for excess fuel. Clean and replace

the spark plug as needed.

7. If the carburetor is flooded or the crankcase is loaded

with fuel, open the drain plug as shown in Figure 7 and

drain excess fuel.

Figure 5. Throttle Control Lever

Figure 6. Recoil Starter

Figure 7. Drain Cock

Operation

1. To start the rammer tamping action, move the throttle lever

quickly from IDLE to the FULL OPEN position (Figure 5) .

DO NOT move the throttle lever slowly as this may cause

damage to the clutch or spring.

CAUTION:CAUTION:

CAUTION:

Make sure that the throttle lever is moved to the

FULL OPEN position. Operating the rammer at

less than full speeds can result in damage to

the clutch springs or foot

2. The MT-85H Tamping rammer is designed to run at 4,000

rpm. At optimum rpm the foot hits at the rate of 665 impacts

per minute. Increasing throttle speed past factory set rpm

does not increase impacts and may damage unit. The MT-

85H is designed to advance while tamping. For faster

advance, pull back slightly on the handle so that rear of foot

contacts soil first.

3. To stop the tamping action, move throttle lever quickly from

the FULL OPEN to IDLE position.

Stopping The Engine

Normal Shutdown

1. Move throttle lever quickly from the FULL OPEN to IDLE

position (Figure 5) and run the engine for three minutes at

low speed. After the engine

cools

, turn the engine start/stop

switch to the “STOP” position (Figure 4) until engine comes

to a complete stop.

2. Close the fuel shut- off valve by moving the strainer lever

upward. See Figure 3.

Emergency Showdown

2. Move the throttle lever quickly to the

IDLE

position, and turn

the engine start/stop switch to the

STOP

position.

MT-85H — OPERATION

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 41 42

Commentaires sur ces manuels

Pas de commentaire

MULTIQUIP Drums MT-85H Manuel d'utilisateur Page 13

Commentaires sur ces manuels

Produits connexes et manuels pour Jouets et accessoires MULTIQUIP Drums MT-85H