Multiquip DCA150SSJU3 Manuel d'utilisateur télécharger pdf (Page 51)

DCA150SSJU3 50 HZ GENERATOR • OPERATION AND PARTS MANUAL — REV. #1 (02/01/10) — PAGE 51

GENERATOR START-UP PROCEDURE (MANUAL)

3. If any abnormalities exists, the warning and emergency

stop lamps on the Engine Operating Panel will be lit.

4. Place the MPEC Control Switch (Figure 45) in the OFF/

Reset position.

5. Place the Diagnostic ON/OFF switch (Figure 43) in the

ON position. Verify that an Active Fault Code message

is being displayed (Diagnostic Display Panel). The fault

code message will continued to be displayed until the

fault has been corrected. Figure 43 illustrates a typical

example of an active fault code message (Low Radiator

Coolant).

Figure 43. Active Fault Code Message

6. In a situation where several engine problems occur

simultaneously, the word “MORE” appears above the

arrow buttons indicating that there are more fault codes

that need to be viewed. Use the arrow buttons to scroll

to the next active fault code.

If desired, the type of fault code, cause of error and

the countermeasures of the error can be referenced

in a separate engine operator’s manual.

7. Before the engine can be started, the engine fault must

be corrected. Also observe that there are no active

fault codes displayed on the diagnostic panel. If no

fault codes are displayed, place the diagnostic switch

in the OFF position.

NOTICE

When the MPEC Control switch is placed in the manual

position, preheating of the glow plugs will begin

automatically and the preheat lamp will stay

lit until the glow plugs are warmed. When the

preheat lamp goes off this signals the

completion of the preheating cycle and the

starting of the engine.

8. To restart the engine due to error codes, place the

MPEC control switch (Figure 45) in the manual

position.

9. If the engine is running smoothly, place the engine

speed switch (Figure 44) in the “HIGH” (up) position.

Figure 44. Engine Speed Switch (High)

10. Verify that the engine running status LED on the

MPEC module (Figure 45) is lit (ON) after the engine

has started.

Figure 45. Engine Running (LED ON)

11. The generator’s frequency meter (Figure 46) should be

displaying the 50 cycle output frequency in HERTZ.

Figure 46. Frequency Meter

12. The generator’s AC-voltmeter (Figure 47) will display

the generator’s output in VOLTS.

Figure 47. Frequency Meter

1 2 ... 46 47 48 49 50 51 52 53 54 55 56 ... 101 102

Commentaires sur ces manuels

Pas de commentaire

Multiquip DCA150SSJU3 Manuel d'utilisateur Page 51

Commentaires sur ces manuels

Produits connexes et manuels pour Générateurs Multiquip DCA150SSJU3