Multiquip MTR35HS Manuel d'utilisateur télécharger pdf (Page 14)

PAGE 14 — MTR-35HS — OPERATION & PARTS MANUAL — REV. #5 (11/09/04)

Stopping The Engine

Normal Shutdown

1. Move throttle lever quickly from the FULL OPEN to IDLE

position (Figure 10) and run the engine for three minutes at

low speed. After the engine

cools

, turn the engine

start/stop

switch to the “OFF” position (Figure 5) until engine comes

to a complete stop.

2. Close the fuel shut- off valve by moving the fuel cock lever to

the CLOSED position. See Figure 4.

Emergency Showdown

1. Move the throttle lever quickly to the

IDLE

position, and turn

the engine start/stop switch (Figure 5) to the

STOP

position.

MTR-35HS — OPERATION

CAUTION:CAUTION:

CAUTION:

Make sure that the throttle lever is moved to the

FULL OPEN position. Operating the rammer at

less than full speeds can result in damage to

the clutch springs or foot

2. The MTR-35HS Tamping rammer is designed to run at 4,100

rpm. At optimum rpm the foot hits at the rate of 750 impacts

per minute. Increasing throttle speed past factory set rpm

does not increase impacts and may damage unit. The MTR-

35HS is designed to advance while tamping. For faster

advance, pull back slightly on the handle so that rear of foot

contacts soil first.

9. If the carburetor is flooded or the crankcase is loaded with

excess fuel, open the drain plug as shown in (Figure 8) and

drain out excess fuel.

Figure 8. Drain Plug

Operation

1. To start the rammer tamping action, move the throttle lever

(Figure 9) quickly from IDLE (close) to the FULL OPEN

position . DO NOT move the throttle lever slowly as this may

cause damage to the clutch or spring.

Figure 9. Throttle Lever (Full Open)

Figure 10. Throttle Lever (Idle)

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 53 54

Commentaires sur ces manuels

Pas de commentaire

Multiquip MTR35HS Manuel d'utilisateur Page 14

Commentaires sur ces manuels

Produits connexes et manuels pour Équipement Multiquip MTR35HS