Multiquip MTR35HS Manuel d'utilisateur télécharger pdf (Page 15)

MTR-35HS — OPERATION & PARTS MANUAL — REV. #5 (11/09/04) — PAGE 15

Maintenance

Perform the scheduled maintenance procedures as indicated:

DAILY

■

Thoroughly remove dirt and oil from the engine and control

area. Clean or replace the air cleaner elements as necessary.

Check and retighten all fasteners as necessary. Check the

spring box and bellows for oil leaks. Repair or replace as

needed.

WEEKLY

■

Remove the fuel filter cap and clean the inside of the fuel

tank.

■

Remove or clean the filter at the bottom of the tank.

■

Remove and clean the spark plug, then adjust the spark gap

to 0.02~0.03 inch (0.6~0.7 mm). This unit has electronic

ignition, which requires no adjustments.

■

Clean air cleaner cover.

200 - 300 HOURS (Pre-Cleaner)

■

Remove the element from the pre-cleaner (Figure 11) at the

top of the crankcase (body side) and clean it with cleaning oil

(kerosene).

MTR-35HS — MAINTENANCE

■

Lubricate the top element (yellow) with 2~5 cc of engine oil

SAE-30.

■

Lubricate bottom element (gray) with 13 ~15 cc of engine oil

SAE-30 and completely squeeze out the excess oil from the

element before installing.

■

The air cleaner on the engine side will hardly be contaminated,

if it is, however after cleaning the element with kerosene, dip

it in mixed oil consisting of 3 parts of gasoline and 1 part of

engine oil. Then tightly squeeze outer primary element

(sponge) and shake off well the inner secondary element

before installing them.

CLEANING THE OIL TANK

■

Clean the inside of the oil tank regularly, preferably 2 or 3 times

a year.

■

In winter, be sure to clean the inside of oil tank to avoid the

freezing of water that may have accumulated inside the tank.

Figure 11. Pre-Cleaner

YELLOW

GRAY

13 -15 CC

SAE 30

2-5 CC

SAE 30

PRE-CLEANER

Figure 12. Oil Tank

CAUTION:CAUTION:

CAUTION:

If water accidently got inside the oil tank, the oil

may appear muddy. If this situation occurs,

simply flush the tank, removing all foreign matter

including water, and fill oil tank with fresh 2-

stroke outboard motor oil.

■

When cleaning the oil tank (Figure 12) perform the following

procedure:

1. Remove the cock holder cover, oil hose, red and black lead

wires from the float sensor.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 53 54

Commentaires sur ces manuels

Pas de commentaire

Multiquip MTR35HS Manuel d'utilisateur Page 15

Commentaires sur ces manuels

Produits connexes et manuels pour Équipement Multiquip MTR35HS